Home › Search › bubble time

“bubble time” search results (2000)

Introduction to the production method of filling powder quality and taste of Italian coffee

Introduction to the production method of filling powder quality and taste of Italian coffee

Espresso is also a key point, that is, uniform, the powder should be uniform in the handle, hot water in the small space near the outlet to gather about 9 Pa of pressure, to rush out of the shackles of pressed powder, loose places will flow too much to cause excessive extraction, dense places will flow less to cause insufficient extraction, then all the efforts above are bullshit that the powder bowl is full of 9 points and the limit of powder thickness is thick.

2016-10-21
Why hot milk can be beaten out of cold milk can not be beaten out of what is the principle caused

Why hot milk can be beaten out of cold milk can not be beaten out of what is the principle caused

Milk latte drinks used in milk fat content is basically around 3%. The less fat, the harder the foam. And you want smooth foam (so forget fat-free cappuccino). The main thing to keep in mind when frothing milk is to stop when the temperature reaches the right point. The appropriate temperature is 55 65C, depending on your taste. frothing

2016-10-18
Detailed explanation of the steps of milking in Italian Coffee

Detailed explanation of the steps of milking in Italian Coffee

There are three things to do when making milk foam: heat the milk, beat the milk foam, add milk to the milk kettle and add milk to 1 to 1 full start the steam valve to release the water in the steam stick. Insert the steam nozzle into the fresh milk surface about 3-5MM deep (depending on the steam nozzle and steam intensity will vary slightly) open the steam valve should hear a slight hiss at this time, control the kettle position

2014-10-30
Five definitions of good milk foam

Five definitions of good milk foam

Five definitions of good milk foam: 1. When you finish your milk foam, the amount of milk foam should not be higher than 20% or 30% of the original milk. When you finish the foam, there should be no uneven bubbles. 3. When you finish the foam, please rotate your cup repeatedly to the left and right. At this time, the foam on the wall of the cup should slowly fall like cream and no bubbles appear in the cup wall. 4. When you are in

2014-09-12
Three methods of making Coffee Milk foam there are three main ways to make coffee milk foam at home

Three methods of making Coffee Milk foam there are three main ways to make coffee milk foam at home

There are three main ways to make coffee foam at home. But either way, it needs to be done with whole milk, which has a fat content of more than 3.7%. Friends who have an Italian coffee machine can generally be made with an Italian coffee machine. The method of making milk foam in the coffee machine Lao Yang mainly used this method in the early days of the Italian coffee machine, but he didn't master it well all the time. Below

2015-11-03
Color of espresso oil Crema Crema espresso espresso mixed with oil

Color of espresso oil Crema Crema espresso espresso mixed with oil

What is crema? Why did crema disappear? A series of complex chemical changes occur during coffee roasting to produce large amounts of carbon dioxide. Most of the carbon dioxide will be released naturally during the storage of ripe coffee beans, but more carbon dioxide will remain in the cell wall. The pump pressure correlation of 9 bar is the insoluble oil in emulsified coffee. actually

2016-07-12
The skill of making latte to beat milk how to beat the foam and heat the milk with the steam of the coffee machine

The skill of making latte to beat milk how to beat the foam and heat the milk with the steam of the coffee machine

Italian coffee machine foam skills 1, do not put the steam pipe into the milk, because there may be some condensed water vapor in the steam pipe, so before preparing to foam, you need to put it for a while to drain the excess water from the pipe. 2. Beginners can insert the thermometer into the container, and then insert the steam pipe obliquely into the milk

2022-08-14
The key points of making Italian coffee fancy coffee: how to use the coffee machine to make good milk foam

The key points of making Italian coffee fancy coffee: how to use the coffee machine to make good milk foam

Have you ever had a cappuccino like this? It looks like a glass of art, but it tastes silky smooth. I hope you did, because that's all there is to a cappuccino. If you've ever had one of these cappuccinos, I think you'll probably agree with me: It's hard to drink a bubbly, fluffy cappuccino. So what makes a real cup of cards

2016-01-07
Boutique Coffee explains the relationship between Coffee and Crema

Boutique Coffee explains the relationship between Coffee and Crema

During the roasting process, a large amount of carbon dioxide is produced in the coffee beans, most of which will be emitted during the cooling process, a few will continue to be kept inside, and the grinding will release these gases, so coffee must be made as soon as possible after grinding. When hot water hits coffee powder under high pressure, it will emulsify the insoluble oil of coffee powder and dissolve a large amount of carbon dioxide supersaturated.

2014-10-29
Key points in the production of espresso: introduction of technical skills and matters needing attention in making milk foam

Key points in the production of espresso: introduction of technical skills and matters needing attention in making milk foam

Espresso machines all espresso machines currently on the market have steam pipes for foaming. The best cup is a stainless steel cup with an outlet. You need the kind of flower cup whose temperature can change with the milk, so you can feel the temperature of the milk at any time without steaming it too hot. Stainless steel happens to have this property. The outlet can help you when you pull flowers.

2015-12-25
Coffee knowledge | take stock of dozens of factors affecting coffee blossom

Coffee knowledge | take stock of dozens of factors affecting coffee blossom

Coffee refers to espresso, first of all, let's talk about extraction: 1.1.The amount of ESP extracted is directly related to the extraction rate of esp. Under the same conditions, the less the liquid is extracted, the higher the concentration is, and the lower the extraction rate is, the better the fluidity and contrast of the oil will be. On the contrary, if there is too much liquid, the oil will be very hard, very watery and the color is very light.

2016-08-06
Analysis of Italian espresso oil Crema concentrated color package concentrated death wish

Analysis of Italian espresso oil Crema concentrated color package concentrated death wish

What is crema? Why did crema disappear? A series of complex chemical changes occur during coffee roasting to produce large amounts of carbon dioxide. Most of the carbon dioxide will be released naturally during the storage of ripe coffee beans, but more carbon dioxide will remain in the cell wall. The pump pressure correlation of 9 bar is the insoluble oil in emulsified coffee. actually

2016-07-01
What is the CREMA of espresso?

What is the CREMA of espresso?

In the process of roasting coffee beans, a large amount of carbon dioxide is produced in the coffee beans, most of which will be released during cooling, and a few will continue to be preserved inside the beans, and these gases will be released when the coffee powder is ground, therefore, the ground coffee powder needs to make coffee as soon as possible. When hot water strikes coffee powder under high pressure, it will emulsify the insoluble oil in coffee powder.

2015-02-13
Teach you how to foam milk

Teach you how to foam milk

Espresso machines All espresso machines currently on the market have steam tubes for frothing milk. Some manufacturers decided to add turbo nozzles to their steam pipes to help their customers. If you have any of these on your machine, please remove them as much as possible, because they won't help us with what we're going to do next. It is best to bring water out of the flower cup

2015-11-12
Italian boutique coffee flower drawing skills to beat the steps of milk foam

Italian boutique coffee flower drawing skills to beat the steps of milk foam

There are three things to do when making milk foam: heat the milk, beat the milk foam, add milk to the milk kettle and add milk to 1 to 1 full start the steam valve to release the water in the steam stick. Insert the steam nozzle into the fresh milk surface about 3-5MM deep (depending on the steam nozzle and steam intensity will vary slightly) open the steam valve should hear a slight hiss at this time, control the kettle position

2015-01-20
Flower drawing skills to dispense with foamed milk, milk fat content and bean espresso

Flower drawing skills to dispense with foamed milk, milk fat content and bean espresso

First, the production of milk bubbles: 1, pour the milk into the milk bubble pot, the amount should not exceed the milk bubble pot 1 big 2, otherwise the milk will overflow due to expansion when making milk bubbles. 2. Heat the milk to about 60 degrees, but not more than 70 degrees, otherwise the protein structure in the milk will be destroyed. Be careful! The lid and strainer cannot be heated directly. (if you make ice milk foam, you will make the cow

2016-04-16
Why did crema disappear the correctly extracted concentrated spaghetti blend coffee bean Crema color?

Why did crema disappear the correctly extracted concentrated spaghetti blend coffee bean Crema color?

What is crema? Why did crema disappear? A series of complex chemical changes occur during coffee roasting to produce large amounts of carbon dioxide. Most of the carbon dioxide will be released naturally during the storage of ripe coffee beans, but more carbon dioxide will remain in the cell wall. The pump pressure correlation of 9 bar is the insoluble oil in emulsified coffee. actually

2016-07-08
Using the method of hot extraction to make the difference between chilled, cold bubbles and ice droplets. Italian spelling of containers containing coffee liquid

Using the method of hot extraction to make the difference between chilled, cold bubbles and ice droplets. Italian spelling of containers containing coffee liquid

The difference between using Hot extraction method to make chilled Coffee, Cold Bubble and Ice droplets using Hot extraction method to make chilled coffee ice coffee refers to coffee powder quickly extracted with hot water, then added with ice or a cold drink coffee after rapid cooling, which takes about 2 to 3 minutes to make. Using cold extraction to make cold-soaked coffee Cold Brew refers to coffee extracted by soaking coffee powder in cold water less than 5 ℃ for a long time, about

2016-07-14
Five skills of making Milk Bubble with Coffee Mechanism

Five skills of making Milk Bubble with Coffee Mechanism

The degree of fusion of foam and milk refers to the degree to which the foam combines with milk after getting rid of the foam.

2014-07-02
Use steam milk foam to make milk foam

Use steam milk foam to make milk foam

1. The choice of appliances (1) Special steel cup: the upper narrow and lower width is easy to form a vortex. (2) thermometer: the sensing speed of ℉ is faster than that of ℃. (3) Milk bubble spoon: egg-shaped strong mouth, easy to scrape off the upper coarse milk bubbles, leaving only dense milk bubbles to increase the import fragrant and smooth feeling. (4) Clean cloth: keep steam pipe clean. two。 The amount of foam will be about 1 beat 3 iced milk (beginners can increase it to 1 beat 2

2014-08-26
↑