DIY hand rack, play the new best part of the DIY coffee tool

It seems that when everyone plays coffee to a certain level, they will make a self-made hand bracket, not for anything else, but for the easy use of X, and, of course, "cash-strapped"! Next, let's make this full hand bracket. It is said that there is a surprise at the end of the article.

Need to be prepared:

-plank (the cedar wood I use is not bad)

-Steel pipe

-set screw

-hacksaw

-oblique chainsaw

-electric drill

-Woodworking bit

-ring hole saw

-sandpaper

-latex glue

-drip filter cup

Production steps:

① uses a skew chainsaw to cut two boards, one big and one small.

② smoothed the surface and surroundings of the board with sandpaper.

③ uses a hacksaw to cut off a steel pipe.

④ drilled a hole in the bottom of the big board with a woodworking bit

⑤ also drilled a hole in the small board in the same way. note that the positions of the two holes are the same.

⑥ uses a circular hole saw to cut a large hole in the middle of a small board, the size of which refers to the middle diameter of the drip filter cup, and then polishes it with sandpaper.

⑦ sawed off half of the fastening screw with a hacksaw and sanded the sawed fastening screw with sandpaper so that it could be better stuffed into the steel pipe.

⑧ put the steel pipe into the hole of the pedestal board and fastened it with latex glue

⑨ fastens the steel pipe with set screws and tightens it with a screwdriver at the right height.

Put on a small plank, put on a drip filter cup, and begin to enjoy your hand-washing journey.

Collection and sharing