Pegasus electric bean grinder disassembly and cleaning demonstration is your bean grinder clean? Does it smell like fuel consumption?

Professional coffee knowledge exchange More coffee bean information Please pay attention to coffee workshop (Weixin Official Accounts cafe_style)

Coffee grinder brand_Coffee grinder which is good_Manual coffee grinder

Recently, many friends said to the boss: how now every bean at home to drink up there is a slight miscellaneous taste!

After asking in detail, I found out that everyone did not clean the bean grinder!

(Every time I polish it, I will use a blow ball to blow out the residual powder. I only grind it two or three times a day...)

Do you regularly check it out?!

If the bean grinder is not cleaned regularly, it will start to produce bad fuel consumption smell for a long time, and even affect your health!!

So the boss will teach his friends how to disassemble the bean grinder on the phone!

Later, I thought about writing an article to teach you how to do a good job of cleaning for your reference

The following is a demonstration of the most common small Pegasus electric bean grinder

All the tools you need.

A cross screwdriver

A coffee brush

One pack of toilet paper

The first step is to remove the upper and lower bean troughs

Step 2 Pick up the screwdriver and remove the left and right screws (note that you have to press the screwdriver slightly to not lose your teeth)

Take the lid off and you'll find a pile of coffee residue that you can't usually clean.

And then carefully remove the cutterhead from inside.

Then take out the small part in the middle of the two cutter heads and the spring

Step 3 Pick up the brush and toilet paper and start cleaning

There are places where there's dirt that has to be removed.

Clean look.

Start pulling the spring. Parts. The cutter head is put back in sequence

Close the front lid again and lock the two screws.

Next, remove the center screw and remove the dial.

cleaning

And then the most important calibration scale.

Plug it in, turn on the motor.

something bad happened

Turn the dial slowly to the right one step at a time (the finer the scale)

until you turn the dial and hear the grinding sound of the cutter head touching each other

One step back is the finest scale.

Then align the graduated cover with the finest graduated locking screw

Done. Clean calibration complete.

The picture below is the powder residue removed!!

combination of upper and lower bean slots

and give you back your clean bean grinder.

Enjoy the clean coffee!

How to adjust the scale thickness of Italian bean grinder